Is there anybody who can help me with following matter?
I want to control 2 of the knobs (e.g. volume and vibrato or reso, or other(s)) with the sensors (Volume and Pitch) on the left and right hand side of my Moog Theremini to control the by hand movements cq hand gestures.
According to Moog it is possible via CC2 (Volume) and CC20 (Pitch) to connect it to USB from Axocontrol.
I am using the patch Little Classic of (Thank you!) TIAR.
I do not know where i can do it. Does anybody know?
The Theremini is recognized by Axoloti:
USB Device Attached
Address (#1) assigned.
cfg desc: num interfaces 2
interface: interface 0, num 0, numep 0, class 1 , sub class 1
interface: interface 1, num 1, numep 2, class 1 , sub class 3
endpoint: interface 1, ep num 0, addr 81
endpoint: interface 1, ep num 1, addr 2
Manufacturer : Moog Music, Inc.
Product : Moog Theremini
Serial Number : 23345678
This device has only 1 configuration.
Default configuration set.
Switching to Interface (#1)
Class : 1h
SubClass : 3h
Protocol : 0h
USB Host Input size requests : 40
USB Host Output size requests : 40
USB Host Output connected to 1 : 2
USB Host Input connected to 1 : 81
MID class st
I know it is not possible to send note MIDI's to axocontrol, but maybe it is possible to use the Windows Axoloti software and use the keyboard within the program!
I tried to find a way, but me as a newbie I don't know where to start and to look a way to find the parameters and the way to match it with the CC Midi codes of the Theremini.
I sthere anyone who can and is willing to help me?