Hi there, so ye something has definitely gone wrong big time with my axoloti. Did some soldering and de-soldering work on the pins PA3 up to the GND next to PA5.
Had a poke about with a multimeter to check before attempting to re-attach header pins, with the positive probe on the VDD connection and the negative probe on the inputs, and ive found none of the Inputs seem to be bridged anywhere with each other, but there is current flowing from the VDDA port i used and the one next to PA5 to all the inputs on the board,and also to all the GND terminals too.
Then in terms of the patcher all inputs are showing the same thing and cannot be moved, which i have included a picture of. Was just wondering if anybody knew would has gone wrong for sure, and what if anything can be done to remedy the situation, its an Axoloti core v1,2 if that makes any difference.
Thank you for your time!