The Push 2 is not compatible with Axoloti , since it uses USB 2.0 high speed.
My plan, is I'm going to run a PI2 that will host axolotis (4 ) and the Push 2, and other controllers on a USB hub...
and the Push 2 will control the axoloti in a similar way to what you see above with the Push 1.
i.e. rather than Push -> Axoloti , I have Push2-> PI2 -> Axoloti(4)
If you want direct control, which I admit was really nice, then go for a Push 1...
the Push 1 was slightly better for this as well, because when running on USB power it was very much still useable, not really the case with the Push2 as it requires alot more power.
I was quite tempted to keep my Push 1 for this, but frankly thought I wouldn't use it enough to justify it. also I figured over time, the cost for a used Push 1 is going to drop, so might pick one up then